CNC Lighting Technology Co., Ltd.
|
Gold Index: 68494
1 The notes of low-frequency induction lamps' installation: In order to guarantee the induction lamp to work under the best situation and produce the best luminous efficiency, when composed with fixture, we should guarantee enough dissipation space for it. In order to guarantee the dissipation of magnet division, we should use magnet division to fix to aluminum blocks to fixture and smear dissipation capacity on the surface. when composed with fixture, the temperature of the lamp shell must under 120℃, the temperature of the fixed magnetic block must under 130℃. The installation temperature under -25℃ needs special description. If you buy our self-supporting induction lamp or electric ballast, you must ask for technicians' guide and confirmation before installation. 2 The notes of electric ballast match with lamps: In order to guarantee the long life and reliability of the electronic components, the working temperature mustn't be too high. If the ballast is outside the fixture, the temperature of the surface must under 60℃, or it will reduce the life of it. So when design for fixture, you should consider of the dissipation of the ballast, install as far as possible from the light source or use a Insulation board to separate the light source away from the ballast. Keep away from water. If the ballast is outside the fixture, the protection level of the ballast shell must reach IP65. If the ballast is insider the fixture, it must keep away from water. The ballast must connect well with the fixture. 3 Before install the induction lamp, please read the instruction carefully, to know the install and fix methods of it and prepare well for the installation steps. The electric ballast has a good self-protecting system. When the lamp doesn’t shine, by cut off the power and then power on you can preliminary determinate if the electrical appliance and the lamp are destroyed. The voltage allows to wave between +10% to -10% of the rated voltage. The temperature of the lamp is high, so when repair it you should cut off the power and let it cool down, to prevent electric shock and burns. The lamp should be installed in ventilated, less dust outdoor environment and doesn’t have corrosive gas, flammable or explosive products. As using a connector to combine the lamp and the ballast, you can’t pull down the lamp in case of power on. The grounding must be reliable not only to guarantee people’s safety, when the lamp matches with ballast need functional grounding. (1, meet the national EMC requirements, never interfere other equipment. 2, guarantee the work of ballast. The product must install and debug by national accredited electric operator.) |