Product name: UL listed Surface Mounted LVD Canopy Light
Model:  CNC-X003

Certificate:

----40-100W Electrodeless Induction Canopy Light


---this is stand for surface mount of the electrodeless induction canopy light


Description of this Surface Mounted Induction Canopy Light:
Square induction canopy light fixtures for many types of parking or garage areas. the prismatic lens creates an even light for low ceiling areas with one of the most popular form used in lighting today. These Induction canopy lights will save your energy over HID lighting and has a 100,000 hour lamp life. It produces a white light which works best with colored security cameras. These are recommended for indoor applications where ceiling mounting heights do not exceed 15 feet. Typical areas include parking garages, maintenance areas, industrial corridors, wash rooms, storage areas and locker rooms.

Light soure of this Surface Mounted LVD Canopy Light: circular induction lamp

Dimension of this Induction Canopy light:
------40W,60W:



----physical sizes of 40W canopy induction light

-----80W,100W



----physical sizes of 80W induction canopy lights

Features:

A. Lamp body of die-casting aluminum, appearance of powder coating, anti-corrosion, durable.

B.PC cover of ultraviolet ray, beautiful and decent, anti-aging.

C. Equipped with ring induction lamp of 40-100w, high luminous efficiency, long life, good color, soft light, light output stable, free-maintenance for long time.

D. Equipped with our own ballast, high power factor, non-flick, lower power loss and constant power.

Application:

Parking, gas station, warehouse and other area.

Photometric of this Surface Mounted Induction Canopy Light: 80W

Construction:

----construction of induction canopy lights

Installation instruction:

1.Remove Philips screws and washers from side of fixture lid(Figure 1)

2.Swing fixture open. Fixture should be hinged on the side opposite the two screws (Figure 1)

3.Disconnect quick connect for ballast. Remove nut securing ground wire. Disconnect RJ45/Power Pack if Fixture is Bi-level.

4.Slide fixture lid off of fixture base at hinge points.

5.Bore holes in mounting surface/concrete using a hammer drill large enough to receive 1/4" concrete anchors (Figure 1).

6.Drill a hole in each of the four standoffs located in the corners of the fixture (Figure 1).

7.Screw 1/4" concrete anchors through lid into pre-drilled holes on mounting surface and secure with nuts.

Application of this Surface Mounted Induction Canopy Light: